CZ 75 TS modifications for IPSC

[Optimistix]

I had just over 1mm taken off front and rear sights last week. Point of impact should theoretically be the same but the gun now prints about 5cm higher at 25 paces.

It fits into the box that Rescomp has at their shop, but will have to wait for Friday's registration to see if it will fit the box used in Florida

I think however I will eventually replace the rear sight with an adjustable sight to enable me to fine tune the sights without the use of a file, dremel or lathe

For now I like the fixed sight as it allows for easy cocking of the gun with the strong hand for a weak hand stage where we will be started mag in and chamber empty ...

[willehond]

Whats happened to point of impact?

I measured both front and rear sights before I began and took off the same amount on both the sights. So my point of impact was basically the same.

[mdaniels]

All treads very I formative, though two years later for me lol