Ruger mini 14

**KK20** · 07-08-2018, 10:45

For the fun of it I ordered some odds and ends for the mini and you get stuff ( shocking I know )

**Miami_JBT** · 12-08-2018, 12:55

http://www.gunsite.co.za/forums/show...nd-Information

**762** · 24-08-2018, 21:07

Good day. Do anyone have the contact number of the Polish engineer that manufactures Mini 14 barrel stabilizers?

**Miami_JBT** · 25-08-2018, 15:28

If you want to increase accuracy in the Mini-14. One of the easiest ways is the gas block. The srcews aren't equally torqued. Remove all four screws, and then have them equally installed and make sure the upper snd lower half of the gas block aren't touching each other.

This was from yesterday.

Went to the range today just to function test my two new Minis and saw on the 50 yard range that someone posted two paper plates. So I taped over the holes and shot both from the bench.

This one is the 1989 made Mini-14 GB.

This one is the new 2018 production Ranch Rifle.

Here they both are from a free standing position just fooling around and doing some rapid fire.

I only brought 60 rounds since it was a quick trip.

I always do that to all my Minis and accuracy does improve.

**KK20** · 25-08-2018, 16:12

I had taken the time out in another post to highlight the importance of this and it was trivialized. ( after all it is only screwed in and what is that gap ...not tight enough ./...) I found that when that is done also take time out to make sure you have a good gas tube and piston. I have a custom one made by John Hall who also emphasized the importance of the fitting of the gas block.