CR Speed WSM II + BHP

[Teamcam]

Good Hellos dearest wise members

I recently purchased a CR Speed WSM II holster which i was hoping to use with my BHP(second hand off the forum)
I received quite a few bits & bobs with it which im battling to figure as there is no instruction manual online available.

When i received, i tried it with my gun immediately before anything, but the trigger guard on my BHP seems bit narrower than what the holster can accommodate.

Is there any way of finding a manual online?
Does anyone have 1 coupled to a BHP?

[Samizat45]

If you can get to PE Pistol And Rifle Club on Saturday I'm sure they would help you.

[Cockroach]

Having just tried to flog one to a mate, I found the following:

1. If it is cut for a Glock, it will have a G stamped under the cut, and has actually been machined thinner, so the spacers won't do the trick.
2. If not Glock cut, you get spacers which screw to the sides to narrow the trigger guard slot.

[Teamcam]

The problem is not much the trigger guard placement..
Its the lock that keeps it in place...

So if i try to tighten the guard gap, it should suffice?
This 1 is the universal so would lie to try to make it work before putting it on the market again

[DJ Vier]

Phone the guys at Rescomp to talk you through it

[Cockroach]

The problem is not much the trigger guard placement..
Its the lock that keeps it in place...

So if i try to tighten the guard gap, it should suffice?
This 1 is the universal so would lie to try to make it work before putting it on the market again

The spacer kit is to tighten it up on the side opposite the latch:

[Teamcam]

The spacer kit is to tighten it up on the side opposite the latch:

Thank you kindly.
This helps alot

[Cockroach]

I reckon, having looked at mine, that you could machine yourself that spacer, or 3D print something.