Glock 43 Mag not dropping

[Steven001]

So I have 5 mags for my Glock 43 and the gun is still at the dealer because Im waiting for CFR, none of the mags drop out the gun when I press the mag release, only about 3-5 mm, and I have tried it with fully loaded mags, my fingers out the way...

I inspected it and it looked like the mag release works fine but the actual grip part of the frame is a bit tight...

Does anyone else have or had the same issue, and if so, how did you fix it?

[singh17]

I have had a similar problem, but it was not the frame.
My problem was the top lip of the Mag, the part that sits just under the tip of the bullet. Not sure how, but they got slightly bent and resulted in the mags not dropping free.
just pressed then a bit on the edge of a table and they were good after that. Also noticed a bit of wear on the plastic at that point.