Its been a while but this week I drilled a 6mm hole through a 300mm long bar to see how far I can realistically push this. The sheer slowness at depth tells me that my little Myford won't go deeper, but I have no doubt that a bigger lathe could go much deeper possibly as far as 500mm. However, the drill might wander too far at that sort of depth. I had no wander at 150 long but I got 0.25mm misalignment at the 150 join in the 300 bar. Testing wasn't difficult - a 5.5mm drill dropped through easily but a 5.8 wouldn't. So I made a 5.7 dia plug which dropped through freely so the error was 0.2 - 0.3. One half may have gone straight while the other half wandered but 0.125 wander in each half is more realistic. Doesn't matter - its not realistic to expect a 6mm drill not to wander a little at 150 deep. 0.25 Will easily be cleaned up by the 7.5mm drill. It'll be a while before I enlarge and ream the hole - 300mm long is considerably more difficult in a small lathe not only because of lack of power but also because of the dimensional limits of the lathe. For example, the 300mm long workpiece mounted in the fixed steady left only 160mm of space for inserting the 200mm long drill bit into the drill chuck. Next time I'll reduce the diameter of the work to 15mm and hold it in the spindle. Not that I'm likely to attempt 300 again because it has no practical value for me - I just wanted to test the possibility. Of course I'll only know if I've succeeded when it reams successfully. My steel is BDMS and I'm sure that 4140 at 30RC will be more difficult and might need carbide drills. Not forgetting that the last drill (8.75mm) must go the whole way through and must therefore be soldered to an extension bar or a 400mm long drill purchased. 400mm long reamer won't be available so that will need an extension piece.

Theoretically the availability of 400mm long drills makes possible 600mm long holes. However, as I've already said it would need a big lathe and drills will probably wander too much at that sort of depth. But that's firmly in the territory of proper gun drills which aren't unreasonably expensive and can be used in big lathes. I'm interested in what can reasonably done with twist drills and small lathes not in pushing them into what is better done with proper gun drills.

But irrespective of how much further I get or don't get I reckon I've almost proved what I sought to prove, which has not as far as I know been published anywhere else. I don't expect anyone else to follow suit, but if anyone with a bigger lathe feels like taking it further I'll be very interested in the results.