Results 1 to 2 of 2
Thread: Big bore stock
-
11-03-2015, 15:37 #1
- Join Date
- Aug 2009
- Location
- Vryheid KZN
- Posts
- 152
Big bore stock
Who in SA does a good job on building a big bore stock that will not set me back an arm and a leg. Will a laminate stock do the job for a .458, and if so, where can I find one. Hoping to get away between 5k and 7k. Any advise will be appreciated.
Regards
Stefan
-
11-03-2015, 16:51 #2
- Join Date
- Dec 2011
- Location
- PTA
- Posts
- 438
Re: Big bore stock
From my investigations a while back, it was going to cost about R4000 just to rough cut(general shape) and do a 95% inletting to the stock from out of a blank piece of wood that I would supply. I was planning do the finishing including checkering myself.
EDITED: If I got the same guy to do the checkering, that would cost anything from R1400-R15000 depending on what you wanted done.
Similar Threads
-
Big Bore Stock Designs...
By Mauser M03 in forum Big Bore RiflesReplies: 14Last Post: 03-10-2014, 12:51 -
Bore axis?
By gertjie87 in forum HandgunsReplies: 3Last Post: 27-04-2014, 11:49 -
Big Bore Available
By jcf250 in forum Firearms / Guns for SaleReplies: 3Last Post: 25-03-2011, 18:37 -
Big Bore Available
By jcf250 in forum Big Bore RiflesReplies: 0Last Post: 21-03-2011, 20:29
Bookmarks