Club 15-22

**Branden88** · 25-01-2023, 15:44

Originally Posted by oafpatroll

EDIT: I'm guessing one could clean up the original with a bit of careful filing or stoning if one wasn't as wealthy as @Branden88 ;-)

I can sell you the original for R550, I'll even send it in the Volquartsen packaging, if you want to try your hand at filing and stoning ;)

**Ocali** · 25-01-2023, 16:39

Originally Posted by Branden88

Just do it, It should take you less than 5 minutes, this video will assist or you can pack a pot scourer into your range bag everytime you go shooting. LOL

Thanks for this, the guy at the gunshot wants to charge me R250 to fit it.. If I can save some bucks, that's another 50rounds I can shoot.

Sent from my PPA-LX2 using Tapatalk

**PeaceOfficer** · 25-01-2023, 17:16

Originally Posted by Ocali

Thanks for this, the guy at the gunshot wants to charge me R250 to fit it.. If I can save some bucks, that's another 50rounds I can shoot.

Sent from my PPA-LX2 using Tapatalk

Norrafok! That's just plain rude.

It's simple enough to DIY. I managed just fine on mine and I was gifted with two left thumbs.

**Branden88** · 25-01-2023, 19:29

Originally Posted by PeaceOfficer

Norrafok! That's just plain rude.

It's simple enough to DIY. I managed just fine on mine and I was gifted with two left thumbs.

This ^^^

Honestly, it will take you less than 5 minutes, I promise. Give it a shot tonight

**Ocali** · 26-01-2023, 12:38

Originally Posted by Branden88

This ^^^

Honestly, it will take you less than 5 minutes, I promise. Give it a shot tonight

Going to give it try today. I got the day off to mess around a bit.

Sent from my PPA-LX2 using Tapatalk

**Vaal** · 26-01-2023, 14:32

Has anybody found out what the MAGIG UNICORN number of is how thick the gauge is to measure the step in the bolt face of a 155-22 to prevent a slam fire?
Was anybody's bolt out of spec and replaced?

**Vaal** · 26-01-2023, 14:48

One day when I'm bored or on pension I'll compare my Volquartsen extractor with the original and see what is the difference. I think with a bit off controlled filing most extractor problems can be fixed except if it needs to be build up at a spot.
My friend has got a Walter. 22 mini rifle with which you could never extract the round out of the chamber. I had a close look at the extractor and saw the problem, with some very carefull filing and a lot of fitting, filing, fitting etc. I got it to work as it was supposed to do.

**ady** · 27-01-2023, 08:06

Originally Posted by Vaal

Has anybody found out what the MAGIG UNICORN number of is how thick the gauge is to measure the step in the bolt face of a 155-22 to prevent a slam fire?
Was anybody's bolt out of spec and replaced?

https://www.gunsite.co.za/forums/sho...y-Recall/page3