Results 1 to 6 of 6
-
25-11-2015, 15:53 #1
- Join Date
- Jul 2012
- Age
- 46
- Posts
- 18
DIY job on focussing holosight dot
I wasn't overly impressed with the Vector holosight that I recently bought. It seemed like the dot was more a comet, with a tail going to the top left corner. I thought it might have had a smudge on the laser, so I cleaned it with an earbud and spiritus. Next moment a thin black film came off the laser and if I peeped through the sight the entire world looked like a very red Christmas tree.
Hours and hours of Googling and watching Youtube videos on anything from holosights, red dots to laser focussing lenses I had decided to perform the operation. For the sake of my ego we will skip through all the failed attempts and jump right to the thing that worked.
A small square of black insulation tape with a needle prick hole stuck over the laser and maneuvered carefully until the hole and the laser aligned. Then I used one of my children's crayons to secure the tape with carefully placed molten wax. This also blocked out light seeping from the side of the laser and reflecting on the holosight lens.
I must say it is a complete pain in the behind to assemble the module. Those tiny little screws are not meant to be handled by a mans hands.
All in all I am very pleased. The dot is much better focused now than with the factory fitted film.
-
25-11-2015, 16:24 #2
- Join Date
- Oct 2010
- Location
- /\/¯¯¯¯¯\/\
- Age
- 43
- Posts
- 10,754
Re: DIY job on focussing holosight dot
how much this optic cost you, if I may ask. hehe
-
25-11-2015, 16:42 #3
- Join Date
- Oct 2011
- Location
- JHB
- Posts
- 3,749
Re: DIY job on focussing holosight dot
What will happen when the wax melts?
-
25-11-2015, 17:08 #4
- Join Date
- Jul 2013
- Age
- 49
- Posts
- 2,004
Re: DIY job on focussing holosight dot
What will the child do without the full range of crayons?
-
02-12-2015, 11:18 #5
- Join Date
- Jul 2012
- Age
- 46
- Posts
- 18
Re: DIY job on focussing holosight dot
I have a buddy that imports all sorts of gun accessories, I paid R1000 for it.
Hopefully the wax won't melt (I really don't feel like opening the thing again).
Ha ha, I only used a few drops off the crayon
-
02-12-2015, 11:34 #6
- Join Date
- Jul 2012
- Posts
- 7,183
Re: DIY job on focussing holosight dot
If it does not hold. Try glue gun next time.
Or epoxy glue.
Bookmarks