Results 1 to 3 of 3
Thread: Vector CR 21
-
02-08-2010, 20:53 #1
- Join Date
- Dec 2008
- Location
- Western Cape
- Posts
- 143
Vector CR 21
Finally had a chance to shoot a CR 21 this weekend.
Good balance,feels very comfortable.
Not a bad buy seeing that semi-auto's are a bit of a problem.
+ looks cool.
Still use to the mag being in front of the trigger though...
Won't say no.
-
02-08-2010, 21:28 #2
Re: Vector CR 21
I have only ever fired two of them but was pretty underwhelmed with those two. I will admit most firing was with NGA ammo, but that red dot sight totally sucked.
Since it was designed as a conversion for the R4 I wonder if one could make an R4 / LM4 / 5 out of one with a few parts?Run Fast, Bite Hard!
-
03-08-2010, 13:59 #3
- Join Date
- Aug 2008
- Posts
- 392
Re: Vector CR 21
It is possible, but the receivers have been machined with an extra hole to accommodate the cr21 trigger, which you need to close it somehow. Also the connection point of were the gas tube slide into the receiver have been machines down to an exceptionally thin rail, which can require reinforcement. Part you will require is a trigger, trigger guard-mag release, pistol grip assembly, folding stock assembly, R/LM Bolt carrier, Gasblock with front sight, Dust Cover with rear sights, Gas tube, Selector assembly, Forend Assembly and time. It’s much easier and cheaper to buy a LM than converting the CR21.
Similar Threads
-
[WANTED] Vector H5 Wanted
By Munchie in forum Firearms / Guns WantedReplies: 9Last Post: 18-10-2013, 11:18 -
[WANTED] Vector SP1
By DA Saint in forum Firearms / Guns WantedReplies: 2Last Post: 16-10-2013, 19:21 -
VECTOR H5
By Algy in forum Firearms / Guns WantedReplies: 11Last Post: 11-06-2011, 04:05 -
Vector CP1
By wormyzn in forum HandgunsReplies: 26Last Post: 03-04-2009, 16:40
Bookmarks